en
Installation
Installation instructions for Tank connection 30018
Description
Einon
®
(
30018
) is a leak-proof intake fuel line.
Getting Started
Parts needed in installation are put in right order and are connected together with
a wire. You shall never cut the installation wire , you’ll need it when installing the
intake pipe. (Installation without the wire is not possible).
Stages
•
Make sure that the fuel tank is empty enough.
• Search about 4 cm flat section from the fuel tank where you can drill a 13
mm diameter hole.
•
Clean the selected area of protection grease and clean also other pos-
sible dirt.
•
Drill a hole.
•
Remove the burr from hole (inside and outside).
•
Figure out without installing for Einon
®
(
30018
) suitable bending and
length.
•
Cut the pipe end diagonally and remove burrs.
•
Install the cut and bent intake pipe through the drilled hole into the tank.
•
Push through the hole into the tank all the other interior parts (up to the
mark), keep the order of parts as they are mounted to the wire.
•
Pull from the wire until the Einon
®
(
30018
) threaded part is outside of the
tank.
•
Turn the Einon
®
(
30018
)
to the correct position and tighten the tank exter
-
nal part (nut).
•
Attach the fuel line to the Einon
®
(
30018
).
MARK
INSIDE TANK PARTS
EXTERIOR
D10381C
- 52 -
XC Duo
490541G