6
humidity or moisture. A short-circuit can warm up the conductors, so that
there isolation will melt or even melt thoroughly. This could lead to fire.
−
Please just use the original cables, which are included in delivery.
They are aligned for your device and guarantee the necessary safety
for you and your device.
−
Don´t operate the device with wet hand or feet.
−
Operate the device only in dry rooms.
−
Don´t operate the device outdoors.
−
Please only follow this instruction manual for cleaning the device.
−
Make sure, that cables and conductors won´t be damaged. Damages
could be caused through heat impact, chemical influence or through
mechanical impacts as rubbing, bending, tearing, rolling over or
nibbling animals.
−
Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before
switching on again.
−
If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord
immediately. Never operate your device with damaged housing,
damaged reflector, defect lamps or damaged power cord. Don´t open
the device. Never repair the device on your own. The device should
only be repaired by electricians.
−
Please follow this instruction manual for maintaining your device.
−
Please just use spare parts, which are conform to the required
specifications.
See
Technical Specifications
.
WARNING
Fire danger through overheating
The device can overheat, if you operate it with covered ventilation slots.
The accessories can overheat, if it does not comply with the necessary
specifications.
The device itself, accessories and easily inflammable materials in close
distance could catch fire.
11
6.2
Mount Octagon Softbox
1. Put the Octagon Softbox cover over the Daylight.
2. Insert the rods in the provided holes at the lamp
ring.
3. Insert the rods in the lugs at the edges of the
Octagon. The black lug can be opened as to facilitate the tension and in
the end it should be closed sturdily. The Softbox cover can be tightened
through the lugs on the device.
4. After mounting the lamps, see
Screw in and out of lamps
, you can
attach the rear diffuser on the Velcro fastener.
5. Put the front diffuser over the Octagon Softbox.
6.3
Screw in and out of lamps
WARNING
Danger of cutting and splitting through breaking or bursting lamp
Don´t let the lamp fall down.
Don´t touch the lamps with bare hands. Just touch the lamp at the plastic
socket or wear clean cotton gloves or use a clean cloth.
ADVICE:
Possible discolouration through burn marks on the lamps
.
1.
Switch off device.
See
Switch device on and off
.
2.
Disconnect from power supply:
Plug out power cord.
3.
Let the device cool down.
CAUTION! Danger of burning on the lamps. Let the device cool down
for approx. 15 minutes.
4.
Screw in lamps:
Screw in lamps carefully.
WARNING! Danger of electric shock. Always screw in all three lamps
as to avoid touching in the sockets, when the device is switched on.
5.
Screw out lamps:
Screw out lamps carefully and store them securely.
