12
6.4
Connect to power supply
1.
Switch off device.
See
Switch on and off of the device
.
2.
Compare the local power supply with the connected load of the device.
See
Technical specifications
.
If the values differ, please contact
or tel. +49 84 32
/ 9489-0.
3.
Connect the power cord with the socket on the device and with the
power socket.
7.
Operation of the device
7.1
Adjust tilt angle
1.
Open tilt lever.
2.
Adjust the required tilt angle.
3.
Tighten tilt lever.
7.2
Switch the device and lamp on and off
The lamps can be switched on and off through the On/Off tappet switch.
1.
Switch on device and lamp:
Set On/Off tappet switch on I.
The lamps light up.
2.
Switch off device and lamp:
Set On/Off tappet switch on O.
The lamps will go out.
8.
Transportation and storage
1.
Switch off device.
See
Switch on and off of the device
.
5
2.
Important safety notes
WARNING
Risk of eye injury
The optical radiation of the lamps could blind your eyes and lead to
afterimages, if persons and animals look into the lamp directly. This could
lead to injuries. Please avoid persons and animals looking into the flash
directly.
WARNING
Danger of crashing, entrapment and fire through the falling down of the
device
The weight of the device is approx. 3 kg.
−
Make sure, that the device is always positioned tilt and skid resistant
and stored securely.
−
Keep out of reach of children and animal. They could overturn the
device.
−
Avoid placing cables where they can be tripped over. The device could
be overturned.
WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage
even if it is switched off. Just after disconnecting the device from the
power supply through pulling out the power cable, the device is actually
de-energized.
−
Switch off your device when it is not in use.
−
Switch off your device before mounting and maintenance and
disconnect from power supply.
−
Protect your device against unintended switching-on.
−
Unplug the power cord, if the flash is not in use for a long time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through
