7
6.
Preparation for operation
6.1
Mount on lamp tripod
WARNING
Mount the device only on the provided lamp tripod.
Make sure, that the tripod with the mounted device has a tilt and skid resistant stand.
•
Put the device with the mounting bracket onto the lamp tripod.
•
Tighten the two fixing screw firmly, so that the device is fixed sturdily.
6.2
Connect to power supply
•
Switch off device.
See
Switch on and off of device
.
•
Compare the local power supply with the connected load of the device.
See
Technical Specifications
.
If the values differ, please contact
or tel. 49 84 32 / 9489-0.
•
Connect the power cord with the socket on the device and with the power socket.
7.
Operation of the device
WARNING
Make sure, that the tripod with the mounted device has a tilt and skid resistant stand.
7.1
Adjust tilt angle
•
Open the left and right fixing screw of the retaining bracket.
•
Adjust the required tilt angle.
•
Tighten the left and right fixing screw on the retaining
bracket.
7.2
Switch device on and off
The lamps can be switched on and off through the On/Off tappet switch on the operation panel.
•
Switch on device.
Set the On/Off tappet switch on I.
The lamps will light up.
•
Switch off lamps.
Set the On/Off tappet switch on 0.
The lamps will go out.
7.3
Adjust output
•
Adjust the required output with the output controller.
Output Controller
