E
33
1. Connect sync cord (included in delivery)
with the connecting socket on the device.
2. The other end of the sync cord should be
connected with the PC jack socket of the
camera.
Prepare flash trigger through remote
receiver (optional)
NOTE
Please note the user information of the
remote receiver manufacturer.
Connect the cable of the remote receiver with
the socket for the sync cord.
Switch on and off of flash trigger through
built-in photo cell
The photo cell enables the device to trigger
through:
• another external device
• on-camera flash devices with integrated
pre-flashes
1. Switch on device.
See Switch the device on and off.
2. Switch on photo cell:
Press push-button SLAVE.
The LED SLAVE lights.
3. Switch off photo cell:
Press the SLAVE button, until it goes out.
Flash triggering via the integrated radio
receiver with the walimex pro radio
remote trigger.
Adjusting the channels on the studio flash.
You can choose from 16 different channels
(F0, F1, F2, F3, ... , FF).
1. Press the SLAVE button on the studio
flash for about 4 sec.
2. The display shows “C..”. Press the SLAVE
button once again, to access the adjust-
ment “F..” (radio channel).
3. Use the arrow keys to adjust the corre-
sponding channels.
4. Press the SLAVE button once again for
approx. 5 sec to save the selected chan-
nel. Or wait approx. 15 seconds, until the
display changes to the start page.
Adjusting channels on the radio remote
trigger (option)
1. Open the battery compartment cover
2. Adjust the studio flash to the radio remote
trigger by displacing the pins accordingly.
Observe the instructions for use of the
radio remote trigger. F0 on the flash unit
represents channel 0, F1 represents chan-
nel 2, and so on.
Adjusting the group function on the
studio flash
In order to avoid alternating interference
signals, they can be adjusted in 4 different
groups in total.
1. Press the SLAVE button on the studio
flash for about 4 sec.
2. The display shows “C..”. Press the
SLAVE button 2 times to access the
adjustment “G..” (group).
3. Use the arrow keys to adjust the desired
group (Ga, Gb, Gc or Gd).
4. Press the SLAVE button once again for
approx. 5 sec to save the selected group.
Or wait approx. 15 seconds, until the
display changes to the start page.
The following table shows how to correctly
adjust the setting between transmitter and
receiver in the studio flash to one another:
