4
c1
s
o
a1
m
e
0.4‘’-3’’
a: Existing Grommet Hole Installation
Place Pole a onto Grommet Base Plate m .
Connect them from the bottom using M5x14
Bolt e and tighten with Allen Key 3mm
.
o
e
a1
m
ja1
j
k
l
p
i
b
:
Self-drilled Grommet Hole Installation
ø 10mm
(ø ")
3/8
Option B: Grommet Base Installation (For saving more space)
0.4‘’-3’’
j
j
k
l
i
a1
OR
Notice:
Please make sure the security nut is installed before you rotate the monitor.
5
If one monitor is lower, remove the Nut h and turn the bolt counter-clockwise using
Allen key 3mm o to raise the monitor. Tighten the VESA Plate e with Nut h for stability
after the adjustment.
4
Put the assembled TV/Monitor onto the Arms & and tighten the VESA Plate e with
Nut h for stability.
Select bolts and spacers (if needed) according to your TV/Monitor. Attach the VESA Plate to the Monitor and tighten with a screwdriver. (Screwdriver not included)
7
For safety, please do not extend the arms too far forward or backward. This may cause
instability and tip over.
6
Guide the cable through the Wire Clips ( n1, n2 ) and store the Allen Keys o in the Wire Clip n1 .
Adjust the tilt angle using Allen Key 5mm n
.
n1
n1
o
n2
Step 3.1
Select Monitor Screws
90°
90°
90°
90°
15°
15°
Step 3.3a
Flat Back Monitor
Step 3.3b
Curved or Recessed Back Monitor
h
h
d
o
o
h
d
c1
d
d
r
s
q
c1 c2
d
d
c2
M4x12
M4x30
Ignore this step if monitors are level.
n2
o
d
h
3
Only one screw size fits your Monitor
Step 3.2
Select Spacers ( if needed )
Hand thread screws into the
threaded inserts on the back
of your Monitor to determine
which screw (M4x12 or M4x30)
to use.
h
h
d
o
n1
o
h
Note:
Please make sure two arms are aligned and balanced.
2
Put the Wire Clip n1 and Arms & through the Poles , adjust the preferred height
and tighten using Allen Key 6mm o . Attach the Wire Clips n1 to the Swivel Arm d .
c1
c1 c2
n2
n1
a
o
o
c2
n2
n1
c1
