Global Parameters – Global Menu
Waldorf microQ User´s Manual
134
Pedal/CV Ctrl. (microQ Keyboard only)
Off/Volume/Control W...Z/Filter 1 Cutoff/Filter 2 Cutoff
Pedal/CV1 Ctrl.
Volume
Sets the controller that is used for the Control Pedal/CV. The respective controller is sent to the
internal tone generation and over MIDI. The following settings are available:
•
If
Off
is selected, no controller is sent.
•
If
Volume
is selected, the volume controller #7 is sent to the internal tone generation and
over MIDI.
•
If
Control W...Z
is selected, the respective controller as set in the Control W...Z setting
page is sent to the internal tone generation and over MIDI.
•
If
Filter 1 Cutoff
is selected, the filter cutoff controller for Filter 1 is sent to the internal tone
generation and over MIDI.
•
If
Filter 2 Cutoff
is selected, the filter cutoff controller for Filter 2 is sent to the internal tone
generation and over MIDI.
PopupTime!LabelTime
1.5s ! 1.5s
PopupTime
0.1s…15.5s
Here you can adjust for how long a time the name and value are shown in the upper right corner of
the display when you perform any parameter edits.
���
As a newcomer to the microQ you should choose a higher setting, around 5-10 sec. After you
have had more experience with the microQ, you might lower this value to around 1.5 sec.
LabelTime
0.1s…15.5s
Here you can adjust for how long a time the menu page name is shown in the upper right corner of
the display when you activate any edit menus.
���
As a newcomer to the microQ you should choose a higher setting, around 5-10 sec. After you
have had more experience with the microQ, you might lower this value to around 1.5 sec.
Display Contrast
0…127
Display Contrast
64
Sets the display contrast. If you accidentally set this parameter to
0
, you may not be able to read the
display any more. If you then switch the microQ off and back on later, it might appear that the
microQ is defective. If this should ever happen, open this manual and proceed as follows:
☞
To restore the Display Contrast to a normal setting:
1.
Power the microQ up.
2.
Press
Global
.
3.
Turn the
Page Dial
clockwise several times and then exactly 4 clicks counterclockwise.