Global Parameters – Global Menu
133
Waldorf microQ User´s Manual
Pedal/CV Offset (microQ Keyboard only)
-64…+63
Pedal/CV Offset
+00
Sets the initial gain for Control Pedal/CV that is used when the pedal is at its
minimum
position. To
find out which value is suited for the Control Pedal/CV you want to use, do the following:
☞
To adjust Pedal/CV Offset:
1.
Set
Pedal/CV Ctrl.
to
Control W
.
2.
Set an empty Standard Modulation Matrix slot of the current sound as follows:
Source
:
Control W
,
Destination:
Pitch
,
Amount:
+
63.
3.
Move the Pedal to its minimum position or make sure that the CV is at its minimum voltage.
4.
Adjust
Pedal/CV Offset
until the pitch is the same no matter if the
Amount
in the Matrix
slot is set to
+00
or
+63
.
Pedal/CV Gain (microQ Keyboard only)
0...127
Pedal/CV Gain
127
Sets the maximum gain for Control Pedal/CV that is used when the pedal is at its
maximum
position.
To find out which value is suited for the Control Pedal/CV you want to use, do the following:
☞
To adjust Pedal/CV Gain:
1.
Perform the steps under
Pedal/CV Offset
.
2.
Set the Matrix slot
Source
to
MAXIMUM
and adjust
Amount
so that you can just hear the
sound with a very high pitch.
3.
Move the Pedal to its maximum position or make sure that the CV is at its maximum
voltage.
4.
Adjust
Pedal/CV Gain
until the pitch is the same no matter if you set
Source
to
MAXIMUM
or
Control W
.
Pedal/CV Curve (microQ Keyboard only)
0...127
Pedal/CV Curve
127
Sets the curve that is used for the Control Pedal/CV. It changes the behaviour of the internal tone
generation and the outgoing MIDI messages. It doesn’t affect incoming MIDI messages.
You can change the settings from
0
to
127
continuously.
���
Depending on the Control Pedal/CV you use, different values might apply. Please try to find out
the best setting yourself.