6
Installation
5. Components
having
adjustments
protected (e.g. paint sealed) by manufacturer are only allowed to
be adjusted by an qualified service agent. They are not to be adjusted by the installation person.
NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system to
the appliance flue outlet.
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Any gas burning appliance requires adequate clearance and ventilation for optimum and trouble-free
operation. The following minimum installation clearances are to be adhered to:
Assembly
GT8600G model only
This model is delivered completely assembled. No further
assembly is required.
NOTE:
•
This appliance is fitted with adjustable feet to
enable it to be positioned securely and level on
uneven floors. This should be carried out on
completion of the gas connection. Refer to the
'Gas Connection Section'.
•
This appliance can also be fitted with rear rollers
to enable the appliance to be easily moved for
positioning and cleaning purposes. If desired,
these rollers are supplied in the packaging, with
the appliance. See below for fitting instructions.
Optional Accessories (Refer to Replacement Parts
List)
•
Plinth Kit. For installation details, refer to the
instructions supplied with each kit.
Fitting Rear Rollers.
1.
Raise the appliance from the floor by approx.
75 mm using suitable lifting equipment (i.e.
Palletiser / Forklift) to allow the rear
adjustable feet to be removed.
2.
Unscrew and remove both the rear adjustable
feet from the rear leg housings.
3.
Fit the rear roller to the rear leg housing and
align the screw hole in the side of the rear leg
housing with the threaded hole in the rear
roller.
4.
Secure the rear roller to the leg support with
the bolt supplied and tighten the bolt using a
10 mm A/F spanner.
5.
Fit the second roller and tighten.
6.
Lower the appliance back to the floor and
adjust the front adjustable feet to level the
appliance.
Combustible Surface
Non Combustible Surface
Left/Right hand side
50 mm
0 mm
Rear
50 mm
0 mm
Fig 1
Appliance
Base
Adjustable
Foot
Rear Roller
Assy
Rear Leg
Housing
Roller
Locating Bolt
