31
Automatic switching
ENG
Setting the luminaire model
Different functions can be switched,
depending on the luminaire model.
The connected luminaire model can be
changed.
Prerequisite:
Settings level
3
is active, see
chapter 6.2 “Activating the settings level”,
X
Move your hand over the centre of the
sensor
B
at a distance of 3.5 cm to
10 cm, see Fig. 1.
The connected luminaire indicates the
current setting by flashing:
Flash-
ing
Setting
1 ×
Luminaire models
S, MS
2 ×
Luminaire model
RGB
X
To change the setting, move your hand
over the sensor again.
The connected luminaire indicates the
current setting by flashing.
X
If you have reached the desired setting:
Wait for 10 seconds.
The set value is applied.
The connected luminaire flashes six
times.
The settings menu is exited.
Setting the dimming level/colour
Depending on the luminaire model, either
the dimming level or the colour with which
the luminaire is switched can be set.
Prerequisite:
Settings level
4
is active, see
chapter 6.2 “Activating the settings level”,
X
Move your hand over the centre of the
sensor
B
at a distance of 3.5 cm to
10 cm, see Fig. 1.
The connected luminaire indicates the
current setting.
X
To change the setting, move your hand
over the sensor again.
The connected luminaire indicates the
current setting.
X
If you have reached the desired setting:
Wait for 10 seconds.
The set value is applied.
The connected luminaire flashes six
times.
The settings menu is exited.
Resetting to the factory setting
The device is reset to the factory setting.
Prerequisite:
Settings level
5
is active, see
chapter 6.2 “Activating the settings level”,
X
Wait while the device loads the fac-
tory setting.
When the factory setting has been
loaded, the connected luminaire flashes
six times.
The settings menu is exited.
