500.0030-D
10
Technical alterations reserved
4.
Guide the left-hand side wall into the
safe diagonally and plug it into the
plug connection in the base. As soon
as the side wall is plugged into the
base, it can be stood upright on the
left-hand side and screwed in (4mm
Allen key) at the centre of the safe
using the cylinder screw.
Caution: Only screw in lightly!
5.
Guide the lid into the safe at an
approx. 45º angle. Clip the tabs of
the lid onto the top of the right-hand
side wall and slowly pivot the lid
upwards. Push the lid slightly to the
right while doing this so that it does
not align to the left-hand side wall
when swivelled up. As soon as the
left-hand tabs of the lid have been
swivelled past the left-hand side wall,
the lid can be pushed slightly to the
left, and the tabs can be clipped onto
the left-hand side wall.
6.
Once the lid is laid on both side
walls, it can be pushed backwards
against the rear wall. Pull the
clamping plate forwards and secure
over the countersunk screw (3mm
Allen key) at the same time.
