1
IMPORTANT INSTRUCTIONS
Important notes and statements about the safe operation and prevention of physical injury and/or
property damage are included throughout this instruction manual.
Always Observe These Safety Instructions!
Safety Instructions to Prevent Personal Injury
In this manual, the following symbols and signs are used to clearly indicate safety instructions:
Warning
Non-observance or misapplication of the contents of the
"Warning" section could lead to a serious accident, including
death or injury.
Caution
Non-observance or misapplication of the contents of the
"Caution" section could lead to serious physical injury to the
user or serious damage to the product.
Warning
(Always read and observe the following instructions to prevent personal injury.)
Damaged or deteriorated tools are very dangerous.
Use only qualified and suitable tools.
Use protective gear.
When disassembling, assembling, and conducting maintenance or when
handling a dangerous type of liquid or a liquid of unknown property, be sure to wear safety gloves, a
helmet, and protective shoes. In addition, when handling wet-end parts, always wear protective
goggles, masks, etc.
Prevent death or injury from a falling pump.
Make sure the rope or chain used for lifting the
pump is not accidentally cut or disconnected during installation. Make sure the rope or the chain
used to lift the pump has sufficient strength for the pump load. Do not to stand underneath a lifted or
suspended pump.
Always turn off the power supply prior to servicing the pump.
Make special provisions so
that the power supply cannot be turned on while someone is working on the pump. In a noisy or
poor visibility environment, display a sign near the power supply switch to notify others that
someone is "WORKING" on the pump. Power mistakenly applied during maintenance may lead to
personal injury.
Check and make sure that there is no one near the pump when switching on the power
supply.
The pump is not equipped with an ON/OFF switch. Connecting the power cable or power
plug supplies the power to the pump and starts the operation.
Run the pump at the specified power supply voltage on the nameplate only.
Fire or electric
shock may result if the supply voltage is incorrect.
If pump operation is stopped due to a power failure or closure of discharge line,
turn off
the power switch at once. After normal conditions are established, reapply power.
