CLEAT INSTALLATION
continued
6. ADJUST THE LIMIT SCREWS TO SET THE DESIRED FLOAT
Tighten the
Limit Screws
to reduce the amount of
float (“heel movement”) experienced by the foot
while pedaling.
Housings are labelled “Heel In” & “Heel Out” to guide
which Limit Screws to adjust.
Preferred float range is unique to each rider. If you are unsure
of your float preference, begin with medium float and adjust as needed.
Note: Do not unscrew the Limit Screws from the Housing when adjusting float,
and do not further tighten the Limit Screws once they have made contact with
the tip of the Spring.
Right Shoe
7. FIT THE CLEAT COVER OVER THE EDGES OF THE PROTECTOR PLATE
Cleat Covers
are labeled “LEFT” or “RIGHT”.
Grip the shoe and apply force with the palm of the hand to each of the four corners
to ensure that the Cleat Cover has properly covered the edges of the Protector Plate.
The Cleat Cover should fit flush to the Cleat Surround when installed correctly.
Note: Failure to properly complete this step may result in the Cleat Cover falling off.
Right Shoe
8. APPLY PTFE DRY LUBE TO THE SPRING (OPTIONAL)
Reduce the engagement force required to clip
into the pedals by applying a small amount of
“PTFE Dry Lube” to the
Spring
.
Wipe away any excess lube.
Right Shoe
Right Shoe - Installed
