320.805.004
16
Date: 2022-02-09
Using the remote AT9S Pro
The AT9S Pro is a different remote control. It is not compatible with the Optima receivers and
therefore the original remote control type should be used. Although the remote looks advance
the platform will run out of the box simply my moving the right joystick.
All other controls are for adjustment purposes. The remote control uses 8 AA batteries.
Connecting the platform
Note that the platform and accompanied remote are connected by default. Should they
disconnect do the following
1.
Access the receiver by removing the cover of the battery pack on the platform.
2.
Hold the remote close to the receiver (max 50 cm).
3.
Click and hold the ID button on the receiver near
the ON/OFF Power Switch of the platform.
4.
The LED on the receiver will flash. When it stops
flashing the remote and platform are connected.
Menu options
Navigating the menu: Hold MODE for 1 second to enter menu, navigate using the Dial, enter menu
points by pressing the PUSH button and exit them pressing the END button. Switch between Basic
menu and Advanced menu by pressing the MODE Button.
To enter the menu the remote must be on the home screen as seen above. Change home screen
by pressing the END Button.
Non-default settings: *ADVANCED MENU
-
PARAMETER
SOUND: OFF
-
MODEL TYPE Type: ACRO, AILE-2: CH6&5, ATL: OFF
-
END POINT
1:AILE 140/140, 2:ELEV 140/140
Lower values for slower top speed
-
REVERSE
1:AILE REV, 2:ELEV NOR
-
*ELEVON
MIX:ACT
-
*SERVO DLY
1:AILE 0%, 2:ELEV 0%
Increase for faster acceleration
When you receive the platform, the remote is trimmed meaning it will run straight forwards when
the joystick is pushed straight forwards. Depending on the load on the platform this may change.
Use the Elevator Trim Lever and Aileron Trim Lever to compensate if necessary.
