4
FOR DIRECT PLUG-IN OPERATION
1. Should you need to use the appliance in corded mode
when the battery is fully discharged, it is best to charge the
appliance in O – OFF position for several minutes before
use. During use, you may notice a decrease in blade
speed. This is perfectly normal. The clipper will still perform
adequately in corded mode with a fully discharged motor.
2. Connect the appliance to the transformer cord, and plug the
wall transformer into an electrical outlet.
3. Move the switch to 1 – ON position.
4. After use, turn to O – OFF position then disconnect wall
transformer from outlet.
REPLACEMENT OF RECHARGEABLE BATTERIES CON
-
TAINS NICKEL-METAL HYDRIDE BATTERIES
Depending on use, your batteries should last three to five years
before replacement is necessary. When replacement is neces
-
sary, follow these steps:
1. Remove blade assembly (1) from appliance
2. Turn appliance upside down (screws should be facing up).
3. Remove all 4 screws (2) from appliance.
4. Carefully remove bottom housing (3) from appliance.
5. Remove batteries (4) from unit and dispose of properly.
6. If replacing batteries, replace with Nickel-Metal Hydride
batteries only. To obtain replacement batteries, call Wahl UK
Ltd on 01227 744330 or visit www.wahlstore.co.uk
IMPORTANT: Place new rechargeable batteries with positive
and negative ends in proper position. Consult drawing of upper
housing of clipper (5) for proper placement.
7. Make sure all parts are seated properly in upper housing of
clipper (5)
8. Place bottom housing of clipper (3) back into proper
placement.
9. Hold case together tightly and replace screws in appliance.
Tighten until snug.
W a h l a n i m a l g r o o m i n g
Where the world goes to look good.
