15. BLADE CARE
BLADES – Avalon & Artiko
To maintain maximum cutting performance and durability of your clippers, the blade set must
be cleaned and oiled regularly.
Never use a blade set that is damaged in any way as this may cause injury.
Whilst in use we recommend the blades are cleaned and oiled at least every 15 minutes.
GENERAL CLEANING PROCESS FOR THE BLADE SET
General Cleaning Process for the Blade Set
1. Switch the clipper off.
2. Remove hair from the blades with the cleaning brush.
3. Use the Hygienic Spray to flush through any grease and dirt.
4. Wipe excess fluid from the blades with a cloth.
5. Apply clipper oil before commencing clipping again.
At the end of each use or if the blade becomes clogged or blocked, it should be
thoroughly cleaned as follows:-
1. Switch the clipper off and remove the blade set from the clipper.
2. Push the top blade to the side (Page 6 Fig. 7) and remove hairs from both blades
using the cleaning brush (Fig. 8).
Do not separate the blades completely.
3. After cleaning, return the top blade to the centre.
4. Hold the blade on it’s side and apply the Hygienic Spray to the top of the blade
allowing the liquid to flush away any dirt or grease.
5. Wipe away any excess fluid from the blade.
6. Oil the blades with Wahl Clipper Oil
7. The top blade should be aligned in the centre of the bottom blade. Do not adjust the
screws on the blade.
8. Attach the blade set to the clipper for continuing use or store the blade in a dry
environment.
NB. The application of oil to a stored blade will eliminate the risk of pitting or rust damage
caused by moisture in the atmosphere.
Only replace a blunt or damaged blade set with Wahl or Moser blades. Replacements may
be ordered through your dealer, service centre or from Wahl (UK) Ltd.
(Contact details on page 18).
ALWAYS OIL NEW BLADES BEFORE USE
Summary of Contents for HorseLine AVALON
Page 1: ......