28
Mounting
WAGO-SPEEDWAY 767
767-4801/000-800 8DO 24V DC 0.5A IF (8xM8)
Manual
Version 1.1.0
Pos: 20 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Monti eren/M ontier en - Überschrift 1 @ 3\mod_1225446744750_21.docx @ 24900 @ 1 @ 1
4
Mounting
Pos: 21.1 /Serie 767 (WAGO-SPEED WAY)/M ontier en/I/O-Modul e/M ontage_Einl eitung 767- xxxx allgemein @ 5\mod_1249028190437_21.docx @ 39640 @ @ 1
The module can be fastened directly to your system using screws. It can also be
mounted on a carrier rail using an adapter or fastened to a profile rail using a
surface mounting profile.
For mounting on a flat surface, WAGO offers spacers to assist in the mounting
process that can be inserted between the 767 Series components. This helps by
providing sufficient mounting distance for compact direct mounting, as well as
eliminating gaps where dirt could accumulate. A cable tie can be fastened through
each of two mounts in the spacer, which together serve to relieve strain from the
sensor or actuator cables.
Pos: 21.2 /Serie 767 (WAGO-SPEED WAY)/M ontier en/I/O-Modul e/M ontage_Hi nweise 767- xxxx allgemei n_1 @ 5\mod_1249028727125_21.docx @ 39643 @ 2 @ 1
4.1
Information on Mounting
The following information shall always be observed:
•
Disconnect the power supply from the system before you start with
installation.
•
The maximum diameter of the drill hole of the module's mounting holes is
not to exceed 4 mm. Otherwise, a full contact with function earth (FE)
socket of the module not be guaranteed. This may lead to restrictions in the
shielding.
•
To protect the module from tensile forces that may arise, do not bridge
spaces with it.
•
Screw the module down only on flat contact surfaces to protect it from
warping.
•
Ensure that the connectors are not soiled during installation. Dirt and other
such substances damage the contacts, allowing corrosion to develop.
•
To avoid damaging the module, do not mount it in shear areas of moving
devices.
•
Arrange for a sufficient potential equalization in your system.
Pos: 21.3 /Serie 767 (WAGO-SPEED WAY)/M ontier en/I/O-Modul e/M ontage_Hi nweise 767- xxxx allgemei n_2 @ 7\mod_1267626531021_21.docx @ 51689 @ @ 1
•
Use all mounting holes to mount the module to your system so all FE
(function earth) connections lie on a ground potential.
Pos: 21.4 /Dokumentation allgemei n/Glieder ungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
