40 Configuration
WAGO-I/O-SYSTEM 758
758-918 Wireless ETHERNET Gateway
Manual
Version 1.0.2
Figure 16: WBM “Easy Config” Page – Confirm Operating Mode Selection
The mode change goes into effect immediately.
Do not refresh or excite the browser window too quickly
When refreshing or closing the browser window, wait until the WEG has
completed the change of mode.
Table 20: WBM “Easy Config” Page – Dropdown Menu
No. Mode
Description
2 Reset configuration to
factory defaults
Reset the configuration to the factory defaults and
reboot the WEG.
*)
3 Reset IP settings to
factory defaults
Resets the IP and DNS settings to the factory
defaults.
Deletes the entries in the table in which the IP
addresses of connected WLAN/
Bluetooth
®
clients
are listed and reboots the device.
*)
4 Await automatic
discovery and
configuration
The WEG waits for the connection attempt of
another device (running in mode 5 or 6) and
automatically creates a WLAN or
Bluetooth
®
network. If unable to establish a connection within
120 seconds, the device aborts the mode and
returns to its previous settings.
**), ***)
5 Configure as WLAN
access point and
scan for clients
Scans for devices running in mode 4. If at least 1
such device is found, the WEG configures itself as a
WLAN access point (AP), sends its connection
configuration to the other device and reboots.
The other device also reboots automatically and
attempts to connect to the access point.
If unable to establish a connection within
120 seconds, the scan operation is aborted and both
devices return to their previous settings.
**)