30
Connect Devices
WAGO-I/O-SYSTEM 750
750-1423 4DI 24V DC 2.0ms, low-side switching, 3-conductor
Manual
Version 1.2.0
6
Connect Devices
6.1
Connecting a Conductor to the Push-in CAGE
CLAMP
®
The Push-in CAGE CLAMP
®
connection is appropriate for solid, stranded and
finely stranded conductors.
Only connect one conductor to each Push-in CAGE CLAMP
®
connection!
Only one conductor may be connected to each Push-in CAGE CLAMP
®
connection.
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Terminate both solid and stranded or ferruled conductors by simply pushing them
in - no tool required. For all other types of conductors, Push-in CAGE CLAMP
®
must be opened for connection with an operating tool with a 2.5 mm blade (order
no. 210-719).
1.
To open the Push-in CAGE CLAMP
®
insert the actuating tool into the
opening above the connection.
2.
Insert the conductor into the corresponding connection opening.
3.
To close the Push-in CAGE CLAMP
®
simply remove the tool - the
conductor is then clamped firmly in place.
Figure 10: Connecting a Conductor to a Push-in CAGE CLAMP
®
