16
English
Title
1. Remove all parts from the pump housing assembly.
3. Clean all parts thoroughly with the brush provided using a
solution appropriate to the type of material you sprayed.
Reassembly (all materials)
1. Place the pump housing ring over the piston chamber.
Slide the spring onto the front end of the piston. Insert
the piston into the rear of the piston chamber.
2. Insert swirl valve into front of the piston chamber. Thread
the spray tip onto the pump housing.
3. Line up the tab on the pump housing with the notch in the
material container. Twist the ring to thread the cup onto
the pump.
4. Take spray cartridge and slide the rear of the piston into the spray gun. Make sure the pegs
(a)
on the cartridge line up with
the guides
(b)
at the bottom of the sprayer. Press cartridge up until it locks into place. Pull on the container to make sure
assembly is locked into place.
3. NOTE - Make sure to completely remove all material
from the inside of the piston chamber by scrubbing
with the brush. Even a small amount of material can
dry like glue and keep the piston from moving,
causing damage to the sprayer.
4. NOTE - Make sure to keep the vent hole (a) on the
pump housing clean and unblocked or a vacuum can
build up in the container and cause damage to the
sprayer. A toothpick or straightened paper clip can
be used to clean it.
(a)
(a)
(b)
Cleaning the components (oil-based materials)
