GB
37
Flexio 867
Malfunction
Cause
Remedy
Atomisation too
coarse
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle contaminated
•
Viscosity of coating material too
high
•
Too little pressure build-up in
container
•
Air filter heavily soiled
•
Amount of air too low
➞
Turn material volume
adjusting screw to the
left (-)
➞
Clean
➞
Dilute
➞
Tighten container
➞
Change
➞
Turn the air volume
control to the right (+)
Spray jet pulsates
•
Coating material in container
running out
•
Nozzle seal worn
•
Air filter heavily soiled
➞
Refill
➞
Replace
➞
Change
Coating material
causes "paint
tears"
•
Too much coating material applied.
➞
Turn material volume
adjusting screw to the
left (-)
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material applied
•
Amount of air too high
➞
Reduce distance
➞
Turn material volume
adjusting screw to the
left (-)
➞
Turn the air volume
control to the left (-)
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
➞
Clean the diaphragm
➞
Replace the diaphragm
Device does not
function
•
Device overheated
➞
Unplug the power
plug, let the device
cool down approx. 30
minutes, do not bend
the hose, check the air
filter, do not cover the
intake slots
Poor covering
capacity on the
wall
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
➞
The material you are
spraying should be at
room temperature
➞
Cross spray (Fig. 13)
➞
Closer to the object
Summary of Contents for WallPerfect Flexio 867
