19
WAGNER Project Pro 117 - 0418B
Figure 18 - Cleaning the Inlet Valve
i
Cleaning or servicing the inlet valve may be required if
the unit has priming problems. Priming problems may
be prevented by properly cleaning the sprayer and
following the long-term storage steps.
1. Remove the suction hose and return tube.
2. Remove the inlet valve unit (a) from the basic unit with an
adjustable wrench. Visually inspect the inside and outside
of the inlet valve assembly. Clean any paint residue with the
appropriate cleaning solution.
3. Replace inlet valve assembly by screwing it into the sprayer.
Parts Lists
Figure 19 - Suction Set
Part #
Description
Quantity
2306606
Suction set assembly ........................................... 1
Figure 20 - Spray Gun/Spray Hose
Item Part #
Description
Quantity
1 0418717
Gun assembly (without nozzle) ....................... 1
2 0418708
Tip, L ........................................................................... 1
3 0418713
Filter, L - XXL+ (white) ......................................... 2
4 2351007
Spray hose, 10m, yellow ..................................... 1
Accessories
Part #
Description
0418705
Spray tip, XS .....................Water-soluble and solvent
based enamels and paints, oils
and release agents
0418706
Spray tip, S .......................Synthetic resin-based paints,
PVC paints
0418707
Spray tip, M ......................Enamel paints, undercoats,
primers, fillers, indoor latex
paints and indoor emulsions
0418708
Spray tip, L .......................Enamel paints, undercoats,
primers, fillers, indoor latex
paints and indoor emulsions,
anti-corrosive paints
0418711
Filter, XS - S (red, 2 pack)
0418712
Filter, M (yellow, 2 pack)
0418713
Filter, L - XXL+ (white, 2 pack)
0418715
Pump section refurbishing kit (No. 5,6,7,8,9,10,11)
All spare parts listed above are wear parts, and are not covered
by warranty.
