37
Plast Coat 15
EDITION 09 /2004
GB
2.1
OPERATION OF THE MORTAR
The coating material is supplied by means of the receptacle.
The spiral conveyor feeds the coating material to the eccen-
tric screw pump. This pump builds up the pressure required
for the transport through the mortar hose. The compressed air
necessary for atomizing the material is supplied to the spray
lance. The mortar spraying machine can be switched on and
off using the electrical remote control. The continuously adju-
stable feed rate of the coating material can be used to create a
soft, even spraying pattern.
2.2
WHAT MATERIALS CAN BE SPRAYED?
• Heat insulating composite system adhesive (mineral and
synthetic resin systems)
• Synthetic resin plasters up to grain size of 4 mm
• Silicate plasters up to grain size 4
• Silicate resin plasters up to grain size 4
• Mineral final coat plaster up to grain size 4
• Light plaster systems up to grain size 4
• Scraped rendering up to grain size 4
• Insulation plaster
• Renovating plaster
• Foam mortar coating
• Quartz plastic
• Roof coatings
• Flameproof coatings
• Mineral sealing slurries
• Bitumen emulsions
• Reinforcing filler
• Liquid wood chip
• Frame sealing mortar
• Synthetic resin rendering base
• Primer
• Filling paints, incl. fiber containing
• Elastic coatings
• Acoustic plaster, synthetic resin bonded
• Filler, synthetic resin bonded
All coating materials should be suitable for applying using
machines. See product data sheet for the coating material to
be used.
Only use other materials after prior consultation with the ma-
nufacturer or WAGNER application technology dept.
3
TECHNICAL DATA
PlastCoat 15
Voltage:
230 V ~, 50 Hz
Fuse protection:
16 A slow-blow
Device mains cable:
6 m long, 3 x 1.5 mm
2
Socket on the control unit-
max. load:
450 watts
Motor output P
1
:
1.5 kW
Max. feed rate (water):
11 l / min
Max. operating pressure:
40 bar
Max. grain size:
K 4 mm
Measurements L x W x H:
1180 x 530 x 660 mm
Receptacle capacity:
60 l
Weight:
70 kg
Tire pressure, max.:
2 bar
Protective system:
IP 54
Max. sound pressure level:
70 dB (A)*
Atomization air connection:
Rapid
action
coupling
DN 7 mm
Max. atomization air
pressure:
10 bar
Required volume of
compressed air, min:
220 l/min
Texture nozzle:
8 mm (standard)
Mortar hose:
DN 27 mm,
10 m (standard)
* Measuring point: At a distance of 1 m to the side of the
unit and at a height of 1.60 m above floor, reverberant floor.
2
INTRODUCTION TO WORKING WITH
THE MORTAR SPRAYING MACHINE
PLASTCOAT 15
The mortar spraying machine PlastCoat 15 can be combined
with continuous flow, gravitation, compulsory or pan mixers
or the processing of mineral coating materials.
The container suction system (accessory) can be used to suck
directly from a container.
INTRODUCTION TO WORKING / TECHNICAL DATA