WAGNER Paint Crew Plus, Owner'S Manual

Page: 14 / 20

14 English
Title
1. Perform
Pressure Relief Procedure,
page 7. Remove
spray gun from the paint hose using adjustable wrenches.
2. Remove filter from spray gun (refer to
Cleaning the
Spray Gun Filter, page 12).
3. Remove spray tip
(a)
from spray guard assembly. 4. Remove washer
(b)
and saddle seat
(c)
located in the
rear of the spray tip assembly. Clean all parts with a soft-
bristled brush and the appropriate cleaning solution.
(b)
(c)
(a)
5. Pour a few drops of household oil inside the gun housing
(see area indicated below by arrow).
6. Reassemble spray gun. Install gun filter tapered-end first,
and install spray tip
(a)
, saddle seat
(c)
and washer
(b)
.
Replace the filter housing and spray guard assembly.
(b)
(c)
(a)
Cleaning the Spray Gun Components
12. If hopper is empty of all cleaning solution, refill with new cleaning solution.
13. Turn the PRIME/SPRAY knob to PRIME, and turn the pump ON.
14. Let the pump circulate the cleaning solution out the return tube for 2-3 minutes. Turn the pump OFF.
15. Remove and thoroughly rinse the hopper once more.
16. Remove and clean the inlet filter (see Cleaning the Inlet Filter , page 12). Replace the filter when clean.
17. Replace the hopper for storage.
NOTE - If you cleaned your pump using mineral spirits, it is necessary that you flush the pump again using warm, soapy
water to prepare it for storage. Repeat ALL Cleanup steps.
Cleanup (continued)