1
Part 1: INSTALLATION INSTRUCTIONS
FOR THE BUTLER MULTI
(Please keep these Instructions for future Reference)
Important Message to the Owner
Please read fully the Operation & Maintenance Instructions with your Butler Multi
BEFORE lighting
your
first fire. Your insurance company may require notification of the installation. Please check.
When a Wet Back is fitted it must be connected to the water supply or damage will result
.
Such damage is not covered by Warranty. Tempering Valves should be installed to the system for safety.
Tempering Valves may be a Permit Requirement. Check with your Building Inspector or Local Council.
BIA: As from 22 April 2003 Automatic Smoke Detectors/Alarms will be mandatory in all new homes and
when solid fuel heating appliances are installed. Permits will not be signed off if alarms are not fitted.
Important Message to the Installer
The Butler Multi has been tested to and complies with AS/NZS 2918:2001- Domestic Solid Fuel
Burning Appliances
The Butler Multi must be installed in accordance with these installation instructions to comply with AS/NZ
2918-2001-Domestic Solid Fuel burning appliances.
Installer’s Responsibilities
Installation of the Butler Multi must be in accordance with these instructions.
Any variation from these installation instructions or any doubts about them must be checked against
requirements of the AS/NZS 2918-2001.The installation must be carried out by a suitably qualified installer.
We recommend using an NZHHA Accredited Technician.
WARNING: THE APPLIANCE AND FLUE SYSTEM SHALL BE INSTALLED IN
ACCORDANCE WITH AS/NZS 2918: 2001 AND THE APPROPRIATE REQUIREMENTS OF
THE RELEVENT BUILDING CODE OR CODES.
THE APPLIANCE AND FLUE SYSTEM SHOULD NOT BE MODIFIED IN ANY WAY
WITHOUT THE WRITTEN APPROVAL OF THE MANUFACTURER.
WARNING: DO NOT CONNECT WET BACKS TO AN UNVENTED HOT WATER SYSTEM
INSTALL IN ACCORDANCE WITH AS 3500.4.1 OR NZS 4603 AND THE APPROPRIATE
REQUIREMENTS OF THE RELEVENT BUILDING CODE OR CODES
CAUTION: MIXING OF APPLIANCE OR FLUE SYSTEM COMPONENTS FROM DIFFERENT SOURCES OR
MODIFYING THE DIMENSIONAL SPECIFICATION OF COMPONENTS MAY RESULT IN HAZARDOUS
CONDITIONS. WHERE SUCH ACTION IS CONSIDERED, THE MANUFACTURER SHOULD BE
CONSULTED IN THE FIRST INSTANCE.
CAUTION: CRACKED AND BROKEN COMPONENTS, e.g. GLASS PANELS OR FIRE BRICKS MAY
RENDER THE INSTALLATION UNSAFE.
Flue System
Must be manufactured in accordance with AS/NZ 2918-2001 and tested to Appendix F. See installation
instruction section on page 5.
PLEASE LEAVE THESE INSTRUCTIONS WITH THE OWNER WHEN THE INSTALLATION IS COMPLETED
