![background image](http://html.mh-extra.com/html/wagan/elite-200w-pro/elite-200w-pro_user-manual_867582009.webp)
©2013 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
8
• Make sure that the television antenna produces a clear signal under normal
operating conditions (i.e. plugged into a standard 110V/120V AC wall
outlet). Also ensure that the antenna cable is of good quality and properly
shielded.
• Sometimes vehicle alternators produce some electrical noise. There are
filters available to mount on the alternator to reduce the noise.
• Change the positions of the inverter, antenna cables, and television power
cord.
• Isolate the television, its power cord, and antenna cables from the 12
volt power source by running an extension cord from the inverter to the
television.
TROUBlESHOOTINg
PROBlEM: low or No Output Voltage – Fault lED lit
Reason
Solution
Poor contact with battery, inverter
terminals, or DC socket.
Clean terminals thoroughly. Reinstall
and tighten. Clean DC socket with non-
metallic abrasive emery stick.
PROBlEM: No Output Voltage – No lEDs lit
Reason
Solution
Blown fuse.
Check vehicle’s Accessory Socket Fuse.
If the fuse is blown, replace with the
same type and rating fuse.