3 Million Brite-Nite Spotlight LED Lantern
by Wagan Tech
3
Using the Spotlight LED Lantern
This Spotlight LED Lantern is versatile and convenient to use. The large handle and rocker
switch placement allows easy control of all lamp functions while carrying the unit. There are
two Rocker type switches. One switch has 2 positions, the other has three positions and are
marked I, 0, and II. Always store the lamp with both switches in the “O” position.
The two rocker switches and their functions are shown in the table below.
Switch Location/Function
Rocker Switch 1
(closest to spotlight end)
Rocker switch 2
“O” Position Function
OFF
OFF
“I” Position Function
Spotlight ON
LED Lantern ON
“II” Position Function
N/A
Flashing Red Emergency
LED ON
IMPORTANT SAFETY INSTRUCTIONS
Charging Your Spotlight
Your Spotlight is supplied with two charging adapters. One adapter is powered by standard
115 volts AC. This is the AC/DC charging Adapter. The other charging Adapter is the DC/
DC Charging Adapter. Be sure to charge the unit completely before the first use. This step
will prolong the life of the internal battery. Use the AC/DC Charging Adapter for the first
charge. Charge the battery for 24 hour before first use.
AC Charging
The AC/DC adapter provides a slow steady charge to the unit. Do not operate the lamp
while the AC/DC Charging Adapter is charging the lamp, you may damage the charging
adapter and discharge the lamp’s batteries. Charge for a maximum of sixteen hours, and do
not overcharge.
1. Make sure that all switches are set to “O”, the off position
2. Plug one end of the AC adaptor into the wall and insert the DC end into the
Charging Jack on the lamp
3. Plug the wall module into an AC outlet
4. The red Charging LED will light up to indicate the lamp is charging
DC Charging
Any 12 Volt DC power outlets, such as ones found in vehicles, boats, and jump starters can
charge this lamp using the DC/DC Charging Adapter. For full charge, the power source must
be from a vehicle or boat DC outlet and the engine should be running. Charge for five hours
maximum. Do not overcharge.
1. Make sure that all switches are set to “O”, the off position
R
www.wagan.com
