©2015 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
14
www.wagan.com
WARNING
THERE IS DANGER OF EXPLOSION. DO NOT CONNECT OR DISCONNECT CHARGER CABLES
DIRECTLY AFTER BATTERY DISCHARGE OR RECHARGE –MAKE SURE THAT THE BATTERY BANK
AREA IS WELL VENTED BEFORE ATTACHING OR REMOVING CABLES.
If the flooded lead-acid batteries are used, as examples given in this document, be sure to make
periodic checks of battery electrolyte levels. Follow battery manufacturer’s instructions in keeping
the electrolyte at the proper level. Be sure to use pure distilled water when replacing evaporated
electrolyte liquid.
Aboard A Vessel Or Vehicle
Manufacturer-supplied, engine-driven alternators can usually be replaced with one that can
continuously deliver higher amperage. This should be done at the outset. Keep the batteries
charging when the vessel or vehicle engine is operating. In the case of a vessel, make sure that
shore power is used to recharge the batteries whenever possible.
OPERATING ISSUES TV AND AUDIO
Although all inverters are shielded and filtered to minimize signal interference, some interference
with your television picture may be unavoidable, especially with weak signals. However, here are
some suggestions that may improve reception.
• First, make sure that the television antenna produces a clear signal under normal operating
conditions (i.e., at home plugged into a standard 110V/120V AC wall outlet). Also, ensure
that the antenna cable is properly shielded and of good quality.
• Change the positions of the antenna cables and television power cord.
• Isolate the television, its power cord and antenna cables from the inerter by running an
extension cord from the inverter to the television set.
• Coil the television power cord or install a clamp-on ferrite choke (available from electronic
parts suppliers).
Note: Some inexpensive audio systems may have a slight “buzzing” sound when operated with
the inverter. This is caused by insufficient filtering in the audio system. The only solution to this
problem is to get a sound system with a higher quality power supply.
Summary of Contents for 2403 AC Inverter
Page 19: ......
