WAFER GSM-DKEY REMOTE CONTROL UNIT
http://www.waferstar.com
INSTALLATION
To install the GSM-DKEY, you need to connect the 2 wires of the relay contact in parallel
with the gate opening button. The relay contacts can stand
48V 0.5A maximum
, this is enough
for its operation but
don't try to switch higher voltages or currents
. You should install the
GSM-DKEY in a place where there is GSM signal coming from the operator you want to use.
Check it with a phone before proceeding with the installation. If you need to install the device in a
place with little signal, you may consider using an external antenna that we may supply as an
option to be purchased separately with 50cm cable.
You should then insert the SIM Card of the operator you want to use with the right direction
according to the following pictures.
!Note! : You must remove the PIN request from the SIM before inserting it in the
unit
, otherwise the device will not work. In order to do so, insert the SIM in a phone and
disable the PIN request (usually there is a security menu that enables you to do so).
Please read this entire manual before installation
!Note!
Take EXTREME care with the high voltage AC220V Power line installation
In case of fault pull the mains adapter out from 220V network immediately.
If device is connect into electricity, you couldn’t take off its cover.
To maximise reception, install the GSM antenna in a prominent elevated position
if possible, and vertically mounted.
The GSM unit requires mounting carefully in a weatherproof enclosure for out
door operation.
Always ensure that the power is switched OFF before inserting or removing a SIM
card from its holder or damage will be caused to the module.
1.Slide back the SIM door and lift it up
2.Slide the SIM Card into the SIM door
making sure that the clipped corner of the
SIM card lines up with the clipped corner
of the SIM holder
3.Close the SIM door
4.Slide the SIM door to lock the SIM card in
place
