EN
Fastening the inverter
SinePower
44
A
NOTICE!
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Fastening the inverter horizontally
➤
Clip two holders on the left bar and two on the lower right bar (fig.
4
,
page 5).
You can move the holders as required.
➤
Fasten the inverter by screwing one screw through each hole in the hold-
ers.
➤
Lay the cable socket (fig.
5
1, page 5) with the clip over the edge on the
back side of the inverter (fig.
5
2, page 5).
➤
Screw the cable socket on with one screw in each of the four holes.
Fastening the inverter vertically
➤
Clip two holders on the left bar and two on the lower right bar (fig.
4
,
page 5).
You can move the holders as required.
➤
Screw the cable socket (fig.
6
1, page 6) on to the wall with one screw
in each of the four holes.
➤
Slide the inverter (fig.
6
2, page 6) onto the cable socket, so that the
edge on the back of the inverter is pinched between the wall and the clip
on the cable socket.
➤
Fasten the inverter by screwing one screw through each hole in the hold-
er.
_MSP702_MSP2524.book Seite 44 Donnerstag, 28. Juli 2011 9:45 21
