EN
Installing the video splitter
VS400
30
To perform the installation, proceed as follows:
➤
Attach the controller and the operating unit to their respective installation
location provisionally.
➤
Install the rear view video system if you have not already done so.
➤
Start up the rear view video system.
If transmission of the camera image is stable, you can carry out the final
installation the controller and operating unit.
6.2
Installing the operating unit
I
NOTE
Make sure the adhesive surfaces (surface and bottom of the unit)
are clean, dry and free of grease.
Proceed as follows:
➤
Glue the velcro strip to the bottom of the operating unit.
➤
Glue the matching velcro strip to a suitable position in the vehicle (fig.
8
,
page 6).
➤
Affix the operating unit.
6.3
Installing the controller
Proceed as follows:
➤
Hold the controller at its installation location and mark the four points for
the drill holes.
➤
Drill the holes, with a Ø of 3.5 mm, at each of the markings.
➤
Screw the controller in place using the 4 mm self-tapping screws (fig.
9
,
page 6).
Summary of Contents for PerfectView VS 400
