Waeco PerfectView VS 400, Installation And Operating Manual

Page: 29 / 236

EN
VS400 Installing the video splitter
29
6 Installing the video splitter
6.1 Tools required
For installation and assembly , you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Electric drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (fig. 1 4, page 3)
 Measuring ruler (fig. 1 5, page 3)
 Hammer (fig. 1 6, page 3)
 Centre punch (fig. 1 7, page 3)
To establish and test the electrical connection , the following tools are re-
quired:

Diode test lamp (fig.
1
8, page 3) or voltmeter (fig.
1
9, page 3)

Crimping tool (fig.
1
10, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves (optional)
To secure the controller and the cables , you may require additional
screws and cable binders.
!
CAUTION!
Select the location of the modules so that they cannot injure the
passengers in the vehicle under any circumstances (e.g. sudden
braking, road traffic accidents).
Observe the following installation instructions:
 The installation location must be protected from moisture and be inside
the vehicle.
 The installation location should be level.
 Before drilling each hole, ensure there is sufficient space on the other side
for the drill head to emerge (fig.
2 , page 4).