Waeco MOBITRONIC RV-RMM-104, Installation And Operating Instructions Manual

Page: 25 / 116

General safety and installation instructions
Depending on the vehicle’s equipment, the following data may need to be repro-
grammed:
Radio-code · vehicle clock · time switch clock · onboard computer · seat position
Instructions on how to reset these can be found in the relevant operating instructions.
Warning! Parts of the LCD ceiling monitor
RV-RMM-70 or RV-RMM-104 which are fastened in the vehicle, must be
fastened in such a way that they do not detach under any circumstances
(hard-braking, traffic accident)
and thus cause injuries of the passengers.
Pay attention when locating the monitor that this is not assembled within
the radius of an AIRBAG. Otherwise there is danger of injury when it is
activated. Do not assemble the monitor within the head-impact range.
Caution! To check the voltage in electrical cables, use only a diode test lamp
(see A 1) or a voltmeter (see A 2). Test lamps (see A 3) with a luminous element
draw too high a current and so the vehicleelectronics can be damaged.
Caution! In order to avoid damages, pay attention that there is sufficient free
space for the drill outlet (see A 4). Every drill hole must be deburred and treated
with a rust-proofing agent.
Caution! Observe when installing the electrical connections that these:
1. are not heavily bent and twisted (see A 5a)
2. do not rub on the edges (see A 5b)
3. are not installed without protection through sharp-edged
openings (see A 5c).
Do not open the equipment since this impairs the tightness and the operability (see A 6).
Do not pull at the cables since this could impair the tightness and the operability of the
devices (see A 7.)
25