Waeco Mobitronic RV-24, Installation And Operating Instructions Manual

Page: 33 / 164

RV-24, RV-27 Mounting the camera
33
z If you are not sure about the location you have chosen, consult the vehicle
manufacturer or dealer.
Tip!
We recommend greasing the threads of the bolts to
prevent corrosion.
When mounting the camera, proceed as follows:
➤
Hold the camera on the chosen location and mark at least two different
points for the drill holes (see
b , page 6).
➤
Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws
(see
c , page 6)
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤
Drill Ø 2 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Stick the double-sided adhesive insulation plate ( 8 5, page 5) to the
assembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤
Screw the camera bracket on with the 4 x 10 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (see
d , page 6)
Ensure that that nuts cannot be pulled through the body shell
when they are tightened.
Use larger washers or metal plates if necessary.
➤
Drill Ø 4.5 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Stick the double-sided insulation plate ( 8 5, page 5) to the assembly
side of the holder.
The insulation plate serves as a seal and protects the paint.
_RV-24_RV-27.book Seite 33 Dienstag, 18. Mai 2004 11:25 11