Maintaining and cleaning MagicWatch
MagicWatch MWE800
46
8.3
Testing the sensors
You can check to see if the sensors are still functioning properly by perform-
ing the following steps:
➤
Drive your car in until it is about 60 cm away from a wall (measured from
a sensor) and square in front of it.
➤
Turn off the engine and but leave the ignition on.
➤
Activate the system with the switch on the display.
✓
MagicWatch should now signal the distance (medium-length sound
sequence).
➤
At a distance of about 30 cm, hold your hand in front of the sensor you are
testing (e. g. the right sensor).
✓
The red LED lights up on the display. The sound sequence changes from
a pulsed tone to a continuous one.
9
Maintaining and cleaning MagicWatch
Caution!
Do not use sharp or hard objects to clean the device as these may
damage the sensors.
➤
Clean the sensors with a damp cloth from time to time.
_MWE-800-4F.book Seite 46 Freitag, 21. Juli 2006 4:28 16
Summary of Contents for MagicWatch MWE800
