MagicSafe MS660
Using MagicSafe
95
✓
The status LED shows the last five saved alarm causes in the form of
flashing signals, in accordance with the following list:
10.8
Using the self-activation function
Self-activation (factory setting: deactivated) refers to the automatic arming of
the alarm system after leaving the vehicle. The ignition must be switched off
for this and the doors must be closed.
To set up self-activation, proceed as follows:
➤
Program software function 7 “Self-activation” to “On”.
✓
The alarm system activates itself 10 sec. after the ignition was switched
off and a door was opened and closed again.
I
NOTE
If you have set the system to self-activate, the central locking does
not
lock the doors, to prevent you locking yourself out of the car by
accident.
Number of
flashes
Cause of the alarm
1
Voltage drop sensor
2
Ultrasonic sensors (interior)
3
Door/boot contact switch
4
Bonnet contact switch
5
Ignition
7
Additional alarm input
8
Radio sensor
9
The battery in the hand-held transmitter is too weak
_MS660.book Seite 95 Montag, 2. August 2010 8:03 20