Waeco CoolMatic CD50, Installation And Operating Manual, Page: 32 / 352

EN
Safety instructions CD50, CRD50
32

If the refrigerator is connected to the DC socket: disconnect the
refrigerator and other electric consumers from the battery
before connecting the quick charging device.

If the refrigerator is connected to the DC socket: disconnect the
refrigerator or switch it off when you turn off the engine. Other-
wise you may discharge the battery.
 The refrigerator is not suitable for transporting substances
which are caustic or contain solvents.
 Keep the drainage outlet clean at all times.
 Do not open the refrigerant circuit under any circumstances.
 Never transport the device in a horizontal position, so that no oil
can leak out of the compressor.
 Make sure that the refrigerator circuit is not damaged during
transportation. The refrigerant in the refrigerator circuit is highly
flammable.
In the event of any damage to the refrigerator circuit:
– Avoid naked flames and sparks.
– Air the room well.

Set up the device in a dry location where it is protected against
splashing water.
2.2 Operating the device safely
D
DANGER!

Do not touch exposed cables with your bare hands. This applies
especially when operating the device from the AC mains.
!
CAUTION!
 Before starting the device, ensure that the power supply line
and the plug are dry.
 If you connect the device to a battery, make sure that no food
comes into contact with the battery acid.
A
NOTICE!
 Do not use electrical devices inside the cooling device unless
they are recommended by the manufacturer for that purpose.
 Do not place it near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.)