Waeco CoolFreeze CDF-18, Instruction Manual

Page: 34 / 288

EN
Operation CoolFreeze
34
CDF36, CDF46: Setting the battery monitor mode
This is how to select the battery monitor mode:
➤
Switch on the cooler.
➤
Press the “SET” button three times.
➤
Use the “ADJUST” button to select the battery monitor mode.
6.5 Using the cooler
A
➤
Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated
air can dissipate.
➤ Close the cooler, see chapter “Connecting the cooler” on page 32.
A
Locking the cooler
➤
Close the lid.
➤
Press the lock (fig. 6 1, page 4) down, until it latches in place audibly.
CDF18: Switching on the cooler
➤
Slide the sliding switch “BATTERY MONITOR” to HIGH if you wish to
operate from a starter battery or to “LOW” if you want to operate from a
supply battery.
I
✓
The “POWER” LED is lit green.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
NOTE
If you wish to operate the cooler from the AC mains, set the bat-
tery monitor to the “LOW” position.