6
1. Press the "INRUSH" button to toggle in the INRUSH mode, ane
the "----" and "INRUSH" will be displayed.
2. Press the trigger to open transformer jaws and clamp onto
single conductor only, and turn on the motor.
3. Read the INRUSH current directly from the display.
4. Depress the INRUSH button for more than 2 second to exit the
INRUSH mode.
5. Minimum input range: >100 dgts
6. The readings of INRUSH measurements will show on the sub-
display.
9. MAX / MIN Button
The "MAX" displays the maximum value of measurements. The "MIN"
displays the minimum value of measurements. press MAX/MIN button
for more than 2 seconds to exit. The recorded value of MAX/MIN
function will show on the sub-display, and the value being measured
will show on the main-display.
10. Backlight Button
Press the button to activate the backlight for approximately 60
second.
11.HOLD Button
Press [HOLD] button to toggle in and out of the Data Hold mode.
In the data hold mode, the " HOLD" annunciator is displayed and
the last reading is held on the display.
Press [HOLD] button again to release the hold and current
readings are once again displayed.
12.Trigger
Press the lever to open the transformer. When the lever is released,
the jaws will close again.
13.Transformer jaws
Pick up the AC or DC current flowing through the conductor. The "+"
marking on the jaw indicates direction of DC current existing on the
conductor being tested which follows forward and vertically with
jaws, and reading shown on display is positive.
2609C.p65
?2009/12/15, 上午 09:15
8
