Wacker Neuson PG1, Operator'S Manual

Page: 22 / 44

wc_tx003931gb_FM10.fm
22
Operation PG1
Continued from the previous page.
6. If the choke lever was moved to the CLOSED position, gradually move it to the
OPEN position as the engine warms up.
7. Allow the machine to warm up in the low speed position for a few minutes.
Note: The machine will begin to pump water with the throttle lever set in the low
speed position.
Adjusting the
pump flow
■
Pump flow is a factor of engine speed.
■
Engine speed is controlled by the throttle lever.
■
Engine speed is infinitely variable between the low speed position and the high
speed position—no tools are required to adjust the position of the throttle lever.
■
In the low speed position (f) , engine speed is approximately 4,700 rpm.
■
In the high speed position (g) , engine speed is approximately 7,000 rpm, which
can yield a flow of up to 130 L/min (34 gpm).
Stopping the
machine 1. Set the throttle lever to the low speed position and allow the machine to run for
approximately 2 to 3 minutes.
2. Set the stop switch to the “OFF” position.
3. Pull the starter grip lightly until you feel resistance, then return it to its starting
position.
NOTICE: This prevents moist air from entering into the machine’s combustion
chamber.
wc_gr012479
f
g