Wacker Neuson HAL 300, Operator'S Manual

Page: 20 / 84

Wacker HAL 300 Maintenance
wc_tx000806gb.fm
EN-18
Check and calibrate in this order:
4.1.1 Check both sides of X axis.
• If X is within spec, proceed to check both sides of Y
• If X needs calibration, calibrate X
4.1.2 Check both sides of Y axis.
• If Y is within spec, proceed to final X to Y check
• If Y needs calibration, calibrate Y; proceed to X to Y check
4.1.3 Final X to Y check: cX, -X, +Y, -Y.
4.2 Calibration Overview
See graphic: wc_gr004601
4.2.1 Calibration is electronic, and is accomplished by using the optional
detector/remote control or the optional small remote control (preferred
methods).
4.2.2 If you do not have a remote, the laser keypad may also be used. This
method will take longer due to the laser making self-adjustments
during movement. Be very careful not to jar or move the laser when
pushing the laser keys, or your calibration will not be accurate.
4.2.3 When in calibration mode, the X or Y LED on the laser keypad should
blink slowly. When the laser is self-leveling or making an adjustment,
the LED will blink rapidly. Wait until the LED blinks slowly again before
proceeding.
Moving the beam to calibrate:
4.2.1 IMPORTANT: When pressing an arrow key to move the beam for
calibration, use short, rapid clicks. Do not hold the key down. One click
will move the beam a very small amount (1/32" at 150' or 1mm at
100m). After pressing the key, the LED will blink rapidly as the laser
reacts. Wait until the LED returns to a slow blink to proceed.
4.2.2 If the +X or +Y axis is toward the wall with the marks, use the ^ key (5)
to raise beam, and the v key (6) to lower beam. If the -X or -Y axis is
toward the wall, it's the opposite: use the v key to raise the beam and
the ^ key to lower the beam.