Wacker Neuson G2.5A, Repair Manual

Page: 31 / 96

Portable Generator Repair Power Requirements
wc_tx000206gb.fm
27
• Loads such as submersible pumps and air compressors require a
very large force to start. They need as much as 3–5 times the wattage
stated on the nameplate in order to start.
If the wattage is not given for a particular tool or appliance, it can be
calculated by multiplying its voltage and amperage requirements:
VOLTS x AMPS = WATTS
•
4.2 Outdoor Installation
Place the generator in an area where it will not be exposed to rain,
snow or direct sunlight. Make sure it is positioned on firm, level ground
so it will not slide or shift. Position engine exhaust away from areas
where people may be present.
If operating the generator inside a tunnel or deep trench, make sure
there is adequate ventilation. Precautions similar to those required
when operating indoors may be necessary.
The surrounding area must be free from water and moisture. All
components must be protected from excessive moisture.
4.3 Indoor Installation
If the generator must be installed indoors, adequate ventilation or
exhaust hoses must be provided. When venting exhaust fumes, make
sure the exhaust piping is large enough to prevent excessive back
pressure to the engine. Back pressure reduces engine efficiency and
may cause the engine to overheat.
Exhaust gas from the engine contains poisonous carbon monoxide
gas; exposure to carbon monoxide can cause loss of consciousness
and may lead to death. Never run generator indoors or in an enclosed
area unless adequate ventilation, through such items as exhaust
hoses or fans, is provided.
When installed indoors, steps to prevent fire and explosion such as
providing a good earthen ground, removing all flammable materials
near generator, and using only electrical cables in good condition,
must be observed. See
Operating Safety.
DANGER