Wacker Neuson 803 Dualpower, Service Manual

Page: 61 / 196

SHB 803 en – Edition 2.4 * 803s312.fm
3-23
Maintenance
Checking the coolant level/adding coolant
Danger!
Never open the coolant reservoir and never drain coolant
if the engine is warm since the cooling system is under high pressure.
Burn hazard!
☞ Wait at least 15 minutes after stopping the engine!
☞
Wear protective gloves and clothing
☞ Open filler cap B to the first notch and release the pressure
☞
Ensure that the coolant temperature is sufficiently low so you can touch the
radiator plug with your hands
Danger!
Coolant is flammable and poisonous.
Accident hazard!
☞
Keep away from flames
☞ Avoid eye contact with coolant
• If coolant comes into contact with the eyes
➥ Immediately rinse with clean water and seek medical assistance
Notice!
Do not add a different coolant to the one in the reservoir.
• Only use the coolant prescribed by Wacker Neuson
– see Fluids and lubricants on page 3-2.
Checking the coolant level
☞ Park the machine on level ground
☞
Stop the engine!
☞ Raise the control lever base
☞
Remove the key and carry it with you
☞ Let the engine and the coolant cool down
☞
Open the engine cover
☞ Check the coolant level on the transparent coolant reservoir 13/ A and on radiator 12/B
☞
If the coolant level is below the lower mark or if there is no coolant at the radiator’s
filler inlet:
➥ Add coolant
☞
Close and lock the engine cover
Fig. 12: Radiator cap
B
A
max.
min.
Fig. 13: Coolant reservoir