Wacker Neuson 28Z3, Operator'S Manual

Page: 115 / 200

OM 28Z3 US – Edition 2.0 * 28Z3b340.fm
3-49
Operation
Adjusting control response:
Characteristic curve 1 (slow movements):
☞
Disengage the starter.
better Switch off ignition
☞
Then move slide switch B to the left D .
☞
Hold slide switch B to the left D and turn the starter key to position “ 1 ” at the same time.
better Hold slide switch B to the left D and switch on ignition
☞
Then release slide switch B.
Status display 42 acknowledges by flashing once.
Characteristic curve 2 (fast movements – maximum throughput):
☞
Disengage the starter.
better Switch off ignition
☞
Then move slide switch B to the right C .
☞
Hold slide switch B to the right C and turn the starter key to position “ 1 ” at the same
time.
Hold slide switch B to the right C and switch on ignition.
☞
Then release slide switch B
➥
Status display 42 acknowledges by flashing twice
Characteristic curves – status display
Displays the characteristic curve that has been selected for the control valve.
Characteristic curve 1 (slow movements):
➥
Indicator light 1 in status display 42 flashes once after turning the starter key to position
“ 1 ”.
better
Indicator light 1 in status display 42 flashes once after switching on ignition.
Characteristic curve 2 (fast movements – maximum throughput):
➥
Indicator light 1 in status display 42 flashes twice after turning the starter key to position
“ 1 ”.
better
Indicator light
1 in status display 42 flashes twice after switching on ignition.
Important!
The characteristic curve that has been set last is active after the machine is started
again.
Fig. 61: Adjusting control response
B
D
C
Fig. 62: Characteristic curves – status display
1
42