Installation
PST2 400
16
wc_tx001980gb.fm
Preparing the Machine for First Use
When the pump is delivered, first perform the following inspection
checks:
•
While unpacking, inspect the product for damage during
shipment, and make sure all bolts and nuts are tightened
properly.
•
Check the model number to make sure it is the product that was
ordered. Be certain it is the correct voltage and frequency.
Note:
If there is any problem with the product as shipped, contact
your nearest dealer or Wacker Neuson representative at once.
3.2
Residue Plate (if equipped)
The residue plate kit contains the residue plate, washers, and bolts.
Reuse nuts from pump assembly.
3.2.1
Remove the strainer
(3)
by loosening the three nuts
(1)
and removing
the three bolts
(2)
. Keep nuts for reuse.
3.2.2
Position washers
(4)
and attach the residue plate
(5)
with new bolts
(6)
included with kit.
Note:
Be certain to use washers to prevent motor shaft stirrer nut from
protruding through residue plate.
CAUTION
Personal injury hazard. Failure to observe this caution can lead to electrical shock,
current leakage, fire, water leakage, or other problems.
Do not operate this product under any conditions other than those for which it is
specified.
