WACKER Group PDT 2, Repair Manual

Page: 44 / 60

Disassembly/Assembly Procedures PD Repair
wc_tx000590gb.fm
40
5.7 Replacing the Engine
See Graphic: wc_gr003459
Removal:
5.7.1 Turn off the engine.
5.7.2 Remove the drain plug (a) and drain the oil from the gearbox.
5.7.3 Remove the screws (f) and lock washers that secure the engine
adapter (b) to the engine.
5.7.4 Remove the screws (c) that secure the bumper bracket (d) and the
rear portion of the engine to the pump housing.
5.7.5 Remove the screws (e) that secure the front portion of the engine to
the pump housing.
5.7.6 Pull, or pry if necessary, the engine away from the gearbox until the
engine shaft is clear of the pump housing.
Installation:
5.7.7 Position shims (g)—either two C-shaped shims or one flat washer per
hole—on the pump housing.
5.7.8 Place the engine onto the shims/pump housing. Turn the engine’s
drive shaft as necessary to align its key with the keyway in the engine
adapter (b).
5.7.9 Slide the engine through the engine adapter and into the gearbox.
Secure the engine to the engine adapter with the screws (f) and lock
washers.
5.7.10 Secure the front portion of the engine to the pump housing with the
screws (e).
5.7.11 Secure the rear portion of the engine and the bumper bracket (d) to the
pump housing with the screws (c).
5.7.12 Refill the gearbox with oil. See chapter Technical Data for amount and
type.