Wachs TRAV-L-VAC 300, Manual

Page: 12 / 24

WACHS TRAV-L-VAC 300
12
1. Shut down engine.
2. Position vacuum system over designated dumping area.
3. If the material collected is primarily solid, first open the
holding tank drain plug to allow any trapped liquids to
escape. open the holding tank dump gate. (Fig 6)
4. It may be necessary to remove any remaining debris from
the holding tank manually.
5. Clean primary filter prior to next use. Filter can be cleaned
with only water, however, mild soap and water are recom-
mended if possible. ( Fig. 7)
OPERATING TIPS
1. While excavating water, always be sure to submerge the
suction tube completely.
2. If debris is packed in the bottom of the valve box, rotate
the suction tube assembly back and forth to break up
debris.
3. For solid debris, pouring water into the valve box greatly
speeds up debris removal.
4. If suction tube on the TLV 300 becomes clogged, use a
rod with a smaller diameter than the inside of tube to as-
sist in blockage removal.
5. For optimal efficiency, flush out suction tubes and suction
hoses prior to storage.
6. Properly performing all scheduled operators maintenance
at the designated times will insure continued peak perfor-
mance and increase the longevity of the TLV 300 unit.
SECTION IV
SET-UP AND OPERATION
Fig. 6
Fig. 7