Wachs 06-030-MAN, User Manual

Page: 27 / 56

Chapter 5, Operating Instructions: Installing the Machine
E.H. Wachs Part No. 06-030-MAN, Rev. 2-0709 23
Mounting the Window Cutter
1.
You will only need two lift hooks on the window cut-
ter frame. Install the hooks at the end of the frame that
will be on top.
2.
Position the crane over the window cutter.
3.
Attach a chain or cable to each lift hook and connect
them to the crane.
4.
Lift the window cutter slowly until the entire machine
is off the floor.
5.
Position the window cutter so that the tracking wheels
at the top are just above the guide ring on the pipe.
Figure 5-8. Set the top of the machine against the
pipe, with the tracking wheels on against the pipe and
on top of the guide ring.
Make sure the
wheels are against
the pipe and are on
top of the guide ring.
6.
Lower the machine gently so that the wheels are rest-
ing on top of the guide ring.
7.
Wrap a binding strap around the pipe and the middle
of the window cutter. Tighten the strap to pull the
machine against the pipe.