INSTALLATION INSTRUCTION
24VDC Dim-To-Warm POWER SUPPLY
A2D50-60, A2D50-96
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
AiSPiRE retains the right to modify the design of our products at any time as part of the company's continuous improvement program
. March 2022
2.
WIRING AND INSTALLATION:
1. Turn Power off at circuit breaker
2.
Mounting
Enclosed 24VDC Dim-To-Warm class 2 output remote power supply at desired location. Measured
a distance between power supply to the beginning of the tape run and make sure that it is under 100ft.The
allowed maximum distance of wires between the output of power supply to the beginning of tape is 100 ft.
The minimum output gauge wire of power supply is 20 AWG.
To extend the cable length (if needed), In Wall Rated Joiner Cable (A2L02) and Joiner Cable Extender
(A2L01-WT) can be used to join between sections as shown below:
To extend the cable length between power supply cable or a wiring box to a tape section, (if needed), In Wall
Rated Extension Cable (A2L03) can be used to join between sections by soldering as shown below:
Wire Color
Dim-To-Warm Power Supply Output
A2L03 Cable
Tape marking
RED
RED
+24VDC
BLACK
BLACK
-3000K/3500K
BLUE/WHITE
WHITE
-1800K
3.
Connect electrical power feed connector to any connector on the tape or accessories. There is no polarity.
Power feed and connectivity can be done with all directions.
A2L01-WT
A2L02
A2L01-WT
A2L03
100 ft. Max