WAC Lighting
www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DeCember, 2014
Fig. 1
PREPARATION
-
Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Remove the screw (F1) and gasket (G1) from the fixture.
2. Secure mounting back plate (C1) to the junction box (A1) using junction box screws (E1). The side of the mounting plate
marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2)
3. Connect the supply wires as shown in Fig. 2, making sure that all wire connectors (B1) are secured. If your outlet box has a green or bare
copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (C1)
using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (FIG. 1)
4. Place the fixture over the mounting plate (C1) and
secure with screws (F1) and gasket (G1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Junction Box
P3 Wire Connector
Mounting Plate
Gasket
Set Screw
Junction Box Screw
B1
C1
G1
F1
E1
INSTALLATION INSTRUCTION
Scoop - Wall Mount
WS-W20506
